Re: PATCH Re: squeeze-slashes false not working?

[Mikael Magnusson <mikachu@xxxxxxxxx>]

On 15 May 2011 20:15, Bart Schaefer <schaefer@xxxxxxxxxxxxxxxx> wrote:
> On May 15, 12:12pm, Mikael Magnusson wrote:
> } Subject: Re: PATCH Re: squeeze-slashes false not working?
> }
> } On 15 May 2011 03:38, Bart Schaefer <schaefer@xxxxxxxxxxxxxxxx> wrote:
> } > This change doesn't fix it for me.  If I apply your patch and then set
> } > accept-exact-dirs yes, then //// completes things in the root between
> } > the first and second slashes, but I'm back to /home/// being treated
> } > as /home/.  There must be something else going on.
> }
> } No idea what then. With /// (//// takes a bit too long), I get all
> } sorts of stuff completed, dev/disk/by-label/, proc/sys/debug/ etc.
>
> Are you starting from zsh -f and setting ONLY the accept-exact-dirs
> zstyle?  Or are you referring to what happens with your full .zshrc?

Oops, that was with my full .zshrc, with zsh -f I get your results.

> } > As an additional observation, even without your patch if I do this:
> } >
> } > % mkdir /tmp/ff /tmp/ffzz
> } > % ls //ff/<TAB>
> } >
> } > I get silent failure.  It completes /tmp if either I leave off the
> } > trailing slash, or if there is at least one file in one of the
> } > directories.  I can't tell if this is the expected behavior or not.
> }
> } ---- no match for: `arg', `directories', `file', or `corrections'
>
> Yes, again I'm in zsh -f so I don't have any descriptions set up.  This
> is what I suspected was the cause.
>
> What's confusing is that if the slash is auto-appended and therefore
> auto-removable, pressing TAB after the trailing slash works the same
> as in the case where you start with no trailing slash.

-- 
Mikael Magnusson